Motor & Chassis Dyno

How to Install your LCD Screen

- Plug the 4pin wire to the LCD and to Port #2 in your dyno board (4 pin connector next to the USB port). - Put your Dyno in setup mode. (Link here (https://support.minipro.com/304318-How-to-Change-the-Settings-Setup-Mode)) - Change Sample Rate (Frequency) to 5hz (see below) - - Change the Board Port #2 to LCD Screen (see below) - - Click "Save" - Click "Disconnect" and close the window. - Switch PIN #8 or Pin #3 to off position (down) - Push the Reset Button fr...

How to change from KPH to MPH

- Put your Dyno in setup mode. (Link here (https://support.minipro.com/304318-How-to-Change-the-Settings-Setup-Mode)) - Change the Torque and Power units to the desire option (see below) - - Click "Save" - Click "Disconnect" and close the window. - Switch PIN #8 or Pin #3 to off position (down) - Push the Reset Button from the back of you dyno board - Done!

How to Solder the A1 Voltage and Current Sensor

Please download video below

How to Change the Settings (Setup Mode)

Instructions: - Open the MINIPRO Software and click "Connect." - Make sure the dyno RPM is reading by rotating the flywheel by hand. - Change Pin #8 (boards with 8 pins are v2.0) or Pin#3 (boards with 3 pins are v2.1) to ON (up position). - Push the Reset Button from the back of you dyno board - If it was done correctly, the settings window will show up. (see below) - - Change the desired units - Click "Save" - Click "Disconnect" and close the window. - Switch PIN ...

How to Change the Frequency (hz)

**Instructions:** * Make sure the windows application (miniPRO for Windows) is closed and the dyno is not working * Select the desired frequency from table below. * Push "Reset" button on the Dyno Electronic Board. * Done! **Note: The frequency rate is reduced when is used with the external LCD.** ------------------------- Frequency Pins to Change 5 Hz 10 Hz (Recommended) 15 Hz 20 Hz 25 Hz 50 Hz

Motor Dyno Ports Information

Item No. Description 1 Eight (8) switches to control your dynamometer settings 2 Reset Button 3 Port #1 - Used for LCD or Throttle Controller 4 Port #2 - Used for Throttle Controller or IR Temp. Sensor 5 Micro USB Port 6 Voltage & Current Port 7 Temperature #1 Port 8 Temperature #2 Port 9 Optical RPM Sensor